Head Hoggers Bagger "Shaft Gripper" Vibranium Shifter bushing

Are you tired of that sloppy hole your (shifter) shaft runs in? Are You ready for a nice tight, smoooooth one? Well, you came to the right place! The new head Hoggers "Shaft Gripper" Vibranium shifter bushing will completely transform how your shifter feels when the bike is warmed up! Gone is the sloppy, shaking rattling shifter your bike comes with and in its place a SMOOTH firm shift! No more missed, or slow shifts, this is how Harley SHOULD have done it!

Available for the Twin cam and M8 up to 2024 engines, be sure to choose the correct one in the order spot!

*IT IS ENTIRELY NORMAL FOR THE BUSHING TO SLIDE INTO THE PRIMARY VERY EASILY IF THE ROOM TEMPERATURE IS BELOW 80 DEGREES, AS THE CASES WARM UP THE MATERIAL WILL EXPAND AND TIGHTEN UP IN THE BORE, the bushings expand and contract with temperature.*

*If you are deleting your heel shift arm, be sure to add the Vibranium "Shaft Cap" to complete the installation, just tap it into place and if you have a slightly loose fit,  just add a dab of silicone to the inside of the cap and slide it on! (The spline OD varies a bit)

**If you want to delete the heel shift arm but want the toe shifter out as far as possible, just add the "Heel shift delete SPACER" and just slide it on the shaft before installing your toe shift arm. 

**DON'T FORGET THE PULLING TOOL IF YOU ARE NOT SETUP TO PULL PRESSED IN BEARINGS! Our CHEAP pulling tool IS EASY and works great and is much cheaper than buying a  complete puller set!**

**INTERNATIONAL CUSTOMERS PLEASE CALL THE OFFICE**